Acer V65XA User Manual page 27

Table 1-6 System Error Messages (continued)
Error Message
Floppy Disk Controller
Error
CPU Clock Mismatch
Serial Port 1 Conflict
Serial Port 2 Conflict
Parallel Port Conflict
Real Time Clock Error
CMOS Battery Bad
CMOS Checksum Error
NVRAM checksum Error
On Board xxx ...
Conflict(s)
PCI Device Error
System Resource
Conflict
IRQ Setting Error
Expansion ROM
Allocation Fail
System Board
Corrective Action
Check the floppy drive cable and its
connections. If the cable is good and
properly connected, the floppy disk
controller may be the problem. Change
the floppy disk controller or disable the
onboard controller by installing another
add-on card with a controller.
When the user changes the CPU
frequency, this message will be shown
once. Then the BIOS will adjust the
CPU clock automatically.
Change the onboard serial port address
in Setup or change the add-on card
serial port address.
Change the onboard parallel port
address in CMOS Setup or the parallel
port address of the add-on card.
Check the RTC circuit or replace the
RTC.
Replace the onboard lithium battery.
Run Setup again and reconfigure the
system.
Run the ECU (Extended ISA
Configuration Utility) to restore the
original EISA configuration data.
Try to reassign or disable onboard
device resources.
Check the PCI card. Replace it if bad.
Run Setup to reconfigure the system.
Run Setup to reconfigure the system.
Change the I/O expansion ROM
address.
1-27