Very Important - TECHWOOD TFR-300A Instruction Manual

THIS FRYER IS EQUIPPED WITH A THERMAL SWITCH WHICH STOPS THE
HEATING IN THE EVENT OF OVERHEATING, (LACK Of OIL, TOO LONG
COOKING etc...)
IF THE FRYER DOES NOT IGNITE, AFTER HAVING CONNECTED IT, (WHEN
YOU TURN THE THERMOSTAT KNOB) YOUR APPARATUS IS NOT
OBLIGATORILY BROKEN DOWN.
IT IS POSSIBLE THAT THE CIRCUIT BREAKER CLOSED THE CIRCUIT.
1. DISCONNECT THE FRYER
2. POSITION THE THERMOSTAT ON 0
3. PRESS ON THE BUTTON LOCATED AT THE BACK OF THE APPARATUS (See
wire storage)
4. REPLUG THE FRYER
5. PRESS ON the "ON / OFF" SWITCH, the Pilot light must ignite!
6. TURN THE THERMOSTAT BUTTON (clockwise) the heating Pilot light must
ignite.
Note: if in spite of that your fryer does not work, do not disassemble it but bring it
back in its original box to your dealer.
GB
Remove the packaging.
Remove the lid of the fryer. The frying basket is in the fryer. Remove all items from
the device.
Note: It is advisable to clean the lid, the outer walls of the appliance, the tray and the
frying basket, as described in CLEANING AND MAINTENANCE.
● Unroll the power cord completely.
● Check that the tension in force in the country where you are, corresponds to that
indicated on the apparatus.
● Connect the apparatus in a socket-outlet in good state, and connected to the
ground, to avoid any danger.

VERY IMPORTANT

Before using for the first time
USE
9