Important Advises; Winter Services; Repair; Torque Moments Bolt Connections - VAN WAMEL Perfect KT 3D-Flex Instruction Manual

Flail chopper
Table of Contents

Advertisement

If possible lubricate with Total Lical EP/ ELF EPEXELF 2 or an equivalent grease.
Viscosity base oil 40°C 190 - 220 Cst.
Thickener Lithium/Calcium compatible.
Temperature range -25°C tot 130°C
Good pressure properties.

1.11 Important advises

1.11.1 Winter services

It is important when taking the mower out of service for a longer period, to carry out the following:
-
Release tension of V-belts
-
Re-new the gearbox oil (see chapter 1.5)
-
Replace the flails if necessary
-
Check which parts have to be replaced or repaired
-
Wash and clean the machine completely, lubricate the bearings and store it in a dry place.

1.11.2 Repair

Urgent repairs and parts supplies are expensive. Why not use the winter (quite) months to bring your machine in a
"PERFECT" condition for the next season.

1.11.3 Torque Moments bolt connections

Bolt connections must through, DIN 267, following list tightened, although is remarked in the manual or parts list.
Size
M8
M10
M12
M14
M16
M18
M20

1.11.4 Caution

No persons, other than the tractor driver, should be near the mower (minimum distance 100 m) whilst it
is in operation. Never walk close to the rear of the machine.
The tractor driver should never leave the tractor seat before disengaging the tractor P.T.O. shaft,
stopping the engine and pulling the tractor key out.
Never remove guards when the machine is operating.
Never touch the machine before being for 100 % sure that all parts ( P.T.O. shaft, blades, belts and
pulleys) have stopped rotating.
Moment Nm, Class 8.8
25
50
85
135
210
290
410
15
Moment Nm, Class 10.9
35
70
120
190
300
410
570

Advertisement

Table of Contents
loading

This manual is also suitable for:

Perfect kt 3d-flex 270Perfect kt 3d-flex 300

Table of Contents