Overloading Clutch P.t.o. Shaft (Option); Bearing Houses / Rotor Shaft; Rear Roller; 3-Point Headstock - VAN WAMEL Perfect KT 3D-Flex Instruction Manual

1.10.2 Overloading clutch P.T.O. shaft (Option)

To ensure correct functioning, friction clutches must be relieved prior to first time use and after lengthy periods of non-
use. To this end, the friction linings must be relieved of pressure and the clutch turned manually.
Notes on relieving of Type K96:
• Uniformly tighten the nuts No. 3, thereby relieving the pressure on the friction disks.
• Turn the clutch.
• Subsequently unscrew the nuts No. 4 again up to the end of the thread.

1.10.3 Bearing houses / rotor shaft

To be lubricate every 8 hours of operation.

1.10.4 Rear roller

To be lubricate every 8 hours of operation

1.10.5 3-Point headstock

The 3-Point headstock has parallelogram arms for side offset and parallelogram arms for bottom following, must be
lubricated at least every 8 operating hours.
14