Download Print this page

Pro-Elec PEL01354 Instructions page 2

Solar wall light

Advertisement

OPERATION
Allow at least 8hrs for the battery to fully charge initially.
NOTE: the lamp does not light except in low ambient light levels.
1.
Operation mode switch
2.
Upper mounting holes
3.
Lower keyhole mountings
Slide the switch to set the mode of operation before installation.
Modes:
Off: the lamp is permanently switched off.
At low ambient light levels:
Mode 1: operates on detection of movement, the lamp illuminates for 30 seconds at
high brightness.
Mode 2: the lamp is lit at low level and on detection of movement the lamp illuminates
for 30 seconds at high brightness then reverts to low level.
Mode 3: the lamp illuminates and remains lit constantly at low level. No motion
detection.
CLEANING & MAINTENANCE
Clean the unit only with a soft damp cloth. Do not use any chemicals, abrasives or
solvents that could damage the casing or lens.
SPECIFICATION
Solar panel: Polycrystal 5.5V 0.75W
Battery: 1 x 2200mAh, Li-ion battery 3.7V non-replaceable.
LED: 45 x white SMD
Colour LED: 6500K, white.
PIR: detection wide-angle lens of 120 degrees, range from 10 to 12m.
Operating modes: 3 modes plus permanently off.
Working time: up to 10 hours.
Dimensions: W172 x H115 x D45mm.
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
2
1
2
85mm
3
Made in China. PR2 9PP
Man Rev 1.1

Advertisement

loading