Pro-Elec PEL01354 Instructions

Please read these instructions carefully before use and retain for future reference.
IMPORTANT SAFETY INFORMATION
• Avoid locations of high temperature or humidity.
• The lamp is rated at IP65 for external use.
WHAT'S INCLUDED
• Lamp assembly.
• User manual.
• Pack of screws and wall plugs.
POSITIONING
• The lamp is suitable for mounting on plasterboard, wood or masonry surfaces.
• It should be mounted in a position of maximum sunlight for optimum charge of the
internal battery.
• Before drilling any fixing holes, check that there are no hidden obstructions behind
the mounting surface such as pipes or cables.
INSTALLATION
• Offer the lamp to the surface and mark the location of the top two exposed fixing
holes.
• Measure vertically down 85mm from each and mark a further two positions.
• Drill the wall and fit the wall plugs if required, then insert screws into the lower two
positions leaving the heads about 3-4mm proud of the surface.
• Set the required mode (see Operation section) then engage the keyhole slots on
the back of the lamp onto the two lower screws then fit and tighten the two upper
screws to fix the lamp firmly into position.
Solar Wall Light
Model: PEL01354
1