Weights And Center Of Gravity - Daikin DBC Series Installation Instructions Manual

Refer to the Roof Curb Installation Instructions for proper
curb installation. Curbing must be installed in compliance
with the National Roofing Contractors Association Manual.
To assist in determining rigging requirements, unit weights
and center of gravity are shown as follows:

WEIGHTS AND CENTER OF GRAVITY

Corner and center of gravity locations
NOTE: Unit should be lifted at a point above
center of gravity.
Data
Corner Weight- A
Corner Weight- B
Corner Weight- C
Corner Weight- D
Unit Shipping Weight
Unit Operating Weight
X (Inches)
Y (Inches)
Data
Corner Weight - A
Corner Weight - B
Corner Weight - C
Corner Weight - D
Unit Shipping Weight
Unit Operating Weight
X (inches)
Y (inches)
The numbers may slightly vary depending on
installed options. These weights are without
accessories installed.
To prevent severe damage to the bottom of the
unit, do not fork lift unit after wood struts
have been removed.
Bring condenser end of unit into alignment with the curb
first. Lower unit carefully onto roof mounting curb. When a
rectangular cantilever curb is used, care should be taken to
center the unit. Check for proper alignment and orientation
of supply and return openings with duct.
Rigging Removal
To prevent damage to the unit, do not allow
crane hooks and spreader bars to rest on the
roof of the unit.
Remove spreader bars, lifting cables and other rigging
equipment.
7
DBC Weights (lbs)
090 102 120
154 205 166
339 315 331
229 273 224
373 313 349
1095 1106 1150
1015 1026 1070
44 49 45
27 28 30
DBH Weights (lbs)
090 102 120
224 254 265
359 347 344
267 300 317
302 311 290
1227 1287 1291
1152 1212 1216
43 44 43
31 30 30
CAUTION
CAUTION
150
211
381
289
327
1288
1208
41
28
150
302
401
312
379
1394
1314
42
29