Install The Monitor; Power Cord - Acer AC707 User Manual

INSTALL THE
MONITOR
• To connect the tilt/swivel base to the monitor, align
hooks with the sockets on bottom side of the
monitor, and gently push the base towards the front
of the monitor.
• The 15-pin D-shell signal connector on the signal
cable will connect easily to the video adapter
output on your personal computer. Lock both
screws on the connector to ensure a firm
connection.
• Turn the PC power switch ON. Then turn the
monitor power switch ON, by pressing the switch
inward. The green power indicator will light up.
• Allow about 30 seconds for the CRT tube to warm
up. Data will be displayed on the screen.
• If your display fails to function properly, please
first refer to the section "Troubleshooting" in this
manual.

POWER CORD

•
Check first to make sure that the power cord you
use is the correct type required for your area.
• This monitor has a universal power supply that
allows operation in either 100/120V AC or 220/
240V AC voltage area. No user-adjustment is re-
quired.
• First connect the power cord into your monitor's
power input socket, and then plug the other end
into a 3-pin AC outlet. The power cord may be
connected to either a wall socket or the power out-
put socket on your PC, depending on the type of
power cord supplied with your monitor.
• For units to be used at 120V AC:
Use a UL Listed Cord Set consisting of a min.
No. 18 AWG, Type SVT or SJT three-conductor
a maximum of 10 ft. in length and a parallel blade,
grounding type attachment plug rated 10A, 125V.
• For units to be used at 240V AC (domestic use):
Use a UL Listed Cord Set consisting of a min. No.
18 AWG, Type SVT or SJT three-conductor cord
a maximum of 10 ft. in length and a tandem blade,
grounding type attachment plug rated 10A, 250V.
• For units to be used at 220/240V AC (outside of
U.S.):
Use a Cord Set consisting of a min.
2
0.75mm ,3G,Type H05VV-F cord and grounding
type attachment plug rated 16A, 250V. The cord
set should have the appropriate safety approvals
for the country in which the equipment will be
installed and marked HAR.
English
E-3