Page 1
All manuals and user guides at all-guides.com SERVICE GUIDE COLOR MONITOR ACER AC511 SERIES 41AS551-ACER-E...
Page 2
All manuals and user guides at all-guides.com THESE DOCUMENTS ARE FOR REPAIR SERVICE INFORMATION ONLY. EVERY REASONABLE EFFORT HAS BEEN MADE TO ENSURE THE ACCURACY OF THIS MANUAL; WE CANNOT GUARANTEE THE ACCURACY OF THIS INFORMATION AFTER THE DATE OF PUBLICATION AND DISCLAIMS LIABILITY FOR CHANGES, ERRORS OR OMISSIONS, MANUFACTURE DATA :Feb-20-03...
All manuals and user guides at all-guides.com TABLE OF CONTENTS PAGE 1. SPECIFICATIONS ..................... 2. PRECAUTION AND NOTICES ................SAFETY PRECAUTIONS ................PRODUCT SAFETY NOTICE ............... SERVICE NOTES ................... HIGH VOLTAGE WARNING ............... 3. OPERATING INSTRUCTIONS ................4. ADJUSTMENT ......................ADJUSTMENT CONDITIONS AND PRECAUTIONS .......
Page 4
All manuals and user guides at all-guides.com 1. SPECIFICATIONS FOR 5G SERIES COLOR MONITOR CRT : 38cm(15V) 90 Deflection, 29mm Neck, 0.28mm Dot Pitch, Non-Glare Screen Viewable image Size: 35cm (13.8") diagonal Display Color: Unlimited Colors External Controls: Power On/Off, OSD key, Function knob: Contrast, Brightness, H-Size, H-Center, V-Size, V-Center, ZOOM, Pincushion, Trapezoid, Rotation, Moire Reduce, Recall, Degaussing, Color Temperature.
All manuals and user guides at all-guides.com 2. PRECAUTIONS AND NOTICES SAFETY PRECAUTIONS Observe all caution and safety related notes located inside the display cabinet. Operation of the display with the cover removed, may cause a serious shock hazard from the display power supply.
All manuals and user guides at all-guides.com should be made to the original design of the monitor. Components shown in the shaded areas on the schematic should be replaced with exact factory replacement parts. The use of unauthorized substitute parts may create a shock, fire or other hazard.
All manuals and user guides at all-guides.com 4. ADJUSTMENT 4-1 ADJUSTMENT CONDITIONS AND PRECAUTIONS Approximately 30 minutes should be allowed for warm up before proceeding. Adjustments should be undertaken only on those necessary elements since most of them have been carefully preset at the factory.
Page 8
All manuals and user guides at all-guides.com CONTRAST H-MOIRE REDUCE BRIGHTNESS V-MOIRE REDUCE H-CENTER R-GAIN H-SIZE G-GAIN V-CENTER B-GAIN V-SIZE R-BIAS ZOOM G-BIAS PINCUSHION R-BIAS TRAPEZOID 9300 COLOR TEMPERATURE PIN-BALANCE 6500 COLOR TEMPERATURE PARALLELOGRAM DEGAUSS ROTATION OSD EXIT RETURN E. To switches the input signal to the other Timing Mode. Please follow step C ~ D to get the optimum picture.
Page 9
All manuals and user guides at all-guides.com D. The adjustment of 6500°K white Balance, May follow step A ~ C , with the x=313 ± 10, y=329 ± 10. E. Full white luminance: (a) Set mode 2 640×480 Fh: 31.5KHz full white pattern. (b) Image Size : H:260±4mm V:195±4mm.
All manuals and user guides at all-guides.com 5. CIRCUIT DESCRIPTION 5-1 MICRO CONTROLLER CIRCUIT MICRO Controller The IC101 contains a 6502 8-bit CPU core,256 bytes of RAM, 16K bytes of ROM,14 channel 8 bit PWM D/A converters, 2 channel A/D converters for key detection, one 8 bit pre-loadable base timer, internal H-sync and V-sync signals processor providing mode detection, watch- dog timer preventing system from abnormal operation, and an I...
Page 11
All manuals and user guides at all-guides.com 5-2 DEFLECTION CIRCUIT The deflection circuit is achieved by a high performance and efficient solution IC 401 (TDA9115) for this monitor. The concept is fully DC controllable and can be used in applications with a micro-controller solutions. The TDA9115 provides sync.
Page 12
All manuals and user guides at all-guides.com 5-3 TRANSISTOR & DIODE CIRCUIT LOCATION CIRCUIT FUNCTION DESCRIPTION D901 ~ D904 Bridge Rectifier for AC Source D910 Clamp Diode for Snubber CKT D919 Rectifier for Output Voltage D922 Rectifier for Output Voltage D923 Rectifier for Output Voltage D925...
All manuals and user guides at all-guides.com 6.TROUBLE SHOOTING CHART 6-1 NO RASTER, CRT RELATIVE CIRCUIT PROBLEMS CHECK MAIN PCB POWER SUPPLY 70V, 15V, 80V CHECK POWER SAVING CIRCUIT, H-SYNC, V-SYNC SIGNAL Q909, Q910 CHECK THE HIGE VOLTAGE REFER ITEM S.M.P.S. OF CRT ABOUT 23.5 ~ 25.5KV CHECK FAILSAFE CKT IC401 PIN 25 RELATIVE CKT.
Page 14
All manuals and user guides at all-guides.com 2.ABNORMAL VIDEO LEVEL ON SCREEN CHECK THE VOLTAGE OF IC801 PIN 2, 16 ABOUT 8V CHECK 8V RELATIVE CIRCUIT CHECK THE SIGNAL INPUT OF R.G.B. ABOUT 0.7Vpp CHECK SIGNAL CABLE OR INTERFACE CARD. CHECK IC801 PIN 11 CLAMP PULSE CHECK THE IC801 PIN 11 RELATIVE CIRCUIT...
All manuals and user guides at all-guides.com 6-2 ABNORMAL DISPLAY 1.NO SIGNAL ON SCREEN CHECK VIDEO IC801 VCC ABOUT 8V CHECK THE 12V PIN OF P802 CONNECTOR CHECK THE OUTPUT VOLTAGE OF IC801 PIN 13, 15, 18 ABOUT 3Vpp CHECK THE RELATIVE CIRCUIT OF IC801 PIN 2/PIN 16 Vcc CIRCUIT CHECK THE B+ VOLTAGE OF VIDEO PCB ABOUT 80V...
All manuals and user guides at all-guides.com 6-3 NO BLANKING CHECK THE RELATIVE CIRCUIT OF BLANKING CHECK THE RELATIVE CIRCUIT OF Q601, Q707 CHECK R859 ON VIDEO PCB, CHECK G1 RELATIVE CIRCUIT FBT PIN 5 ON MAIN PCB 6-4 HOR./OSC/DEF/HV CIRCUIT FAULT 1.
All manuals and user guides at all-guides.com 6-5 ABNORMAL HORIZONTAL DEFLECTION 1. ABNORMAL HORIZONTAL WIDTH OF VIDEO READJUST H-WIDTH FUNCTION CHECK THE RELATIVE CIRCUIT OF Q404, Q405, & Q406 CHECK FBT B+ VOLTAGE ABOUT 70V AT FH=31KHz CHECK THE RELATIVE CIRCUIT OF SMPS.
All manuals and user guides at all-guides.com 6-6 ABNORMAL VERTICAL SCANNING 1. ABNORMAL VERTICAL SIZE READJUST V-SIZE FUNCTION VALUE CHECK THE IC601 PIN 2 ABOUT 11.8V PIN 4 ABOUT -12V CHECK D601, C605 RELATIVE CIRCUIT CHECK VERT. OSC CIRCUIT CHECK THE VOLTAGE OF IC101 RELATIVE CIRCUIT READJUST V-SIZE FUNCTION VALUE CHECK IC401 PIN 20, 21, 22, 23...
All manuals and user guides at all-guides.com 6-8 POOR FOCUS READJUST FOCUS CONTROL CHECK FOCUS CONTROL UNIT, FOCUS LEAD WIRE, CRT SOCKET & CRT 6-9 NO SOUND (OPTIONAL WITH AUDIO ONLY) CHECK IC501 ADJUST VOLUME CONTROL PIN 14 ABOUT 14V CHECK POWER SUPPLY CIRCUIT ENSURE THE SOUND SOURCE...
All manuals and user guides at all-guides.com 6-10 POWER SUPPLY TROUBLE SHOOTING CHART BEFORE CHECK SW.REG. PLEASE REFER TO THE POWER SUPPLY BLOCK DIAGRAM POWER SUPPLY OUTPUT: (A) VARIABLE OUTPUT : 60.5V - 145V (DEPENDING EPENDING UPON H.SYNC FREQUENCY) CONSTANT OUTPUT : 6.3V, 14.5V, -12V, 80V BEAD SET ABNORMAL VARIABLE OUTPUT MAKE SURE THAT...
All manuals and user guides at all-guides.com 7. MECHANICAL OF CABINET FRONT DIS-ASSEMBLY...
Page 22
All manuals and user guides at all-guides.com PARTS LIST OF CABINET LOCATION S551VSHWAEN2R SPECIFICATION REMARK CMS551VAY2 CHASSIS FOR S551V ACER 1A 503501 47 CRT SCREW 5A 38 8 RUBBER WASHER BOARD 11A 112500 WIRE MOUNT 11A 115 1 FBT CLIP...
Page 23
All manuals and user guides at all-guides.com LOCATION CMS551VAY2 SPECIFICATION REMARK AMS551VAY MAIN BOARD FOR S551V AC CRS551VAY CRT BOARD FOR S551V ACE 1A 421 4128 SCREW 11A 141 1 PCB SUPPORT 40A 581 26702 FAIL-SAFE LABEL 40A 581624 2B CHASSIS LABEL 84A 33 10 FUSE CLIP...
Page 28
All manuals and user guides at all-guides.com D931 95A 90 23 TIN COATED D939 93A 64 1152T DIODE 1N4148 D942 93A 64 1152T DIODE 1N4148 D960 95A 90 23 TIN COATED D990 93A 64 1152T DIODE 1N4148 D995 93A 64 1152T DIODE 1N4148 FB081 71A 55 9 T...
Page 29
All manuals and user guides at all-guides.com J047 95A 90 23 TIN COATED J048 95A 90 23 TIN COATED J049 95A 90 23 TIN COATED J050 95A 90 23 TIN COATED J051 95A 90 23 TIN COATED J052 95A 90 23 TIN COATED J055 95A 90 23...
Page 30
All manuals and user guides at all-guides.com J113 95A 90 23 TIN COATED J115 95A 90 23 TIN COATED J117 95A 90 23 TIN COATED J118 95A 90 23 TIN COATED J119 95A 90 23 TIN COATED J120 95A 90 23 TIN COATED J126 95A 90 23...
Page 31
All manuals and user guides at all-guides.com Q407 57A 419503 T 3DG945P Q408 57A 419503 T 3DG945P Q420 57A 498 3 T HBF423 Q471 57A 420501 T PNP TRANSISTOR KTA733P Q601 57A 419502 T 3DG1815Y Q701 57A 419503 T 3DG945P Q702 57A 420501 T PNP TRANSISTOR KTA733P...
Page 39
All manuals and user guides at all-guides.com LOCATION PARTS No. SPECIFICATION REMARK C108 65A 44222013T 22PF +-5% NPO 50V IC101 56A1125510 WT62P1 IC102 56A113312A M24C04-BN6 IC105 56A1131514 WT OSD IC J133 95A 90 23 TIN COATED X101 93A 22 43 H 12MHz PARTS LIST OF Q911 ASS'Y LOCATION...
Page 40
All manuals and user guides at all-guides.com 95A205T 30052 Q403 57A 706506 2SC5928 Q406 57A 415 1 TR.NPN TIP122/FAIRCHILD R426 61A153M270 59 MOFR 27 OHM +-5% 3W R428 61A153M109 59 MOFR 1 OHM +-5% 3W PARTS LIST OF Q403/D408/Q406 ASS'Y LOCATION PARTS No.
Page 41
All manuals and user guides at all-guides.com LOCATION PARTS No. SPECIFICATION REMARK 750A59165AV 15" CPT CRT C426 63A210J1042CC 0.1UF +-5% 250V C450 65A 1K101 5T6285 100PF/1KV Y5P+-10% C480 65A 1K101 5T6285 100PF/1KV Y5P+-10% 95A201F 50102 R456 61A153M151 59 MOFR 150 OHM +-5% 3W R461 95A 90 23 TIN COATED...
Page 42
All manuals and user guides at all-guides.com BLOCK DIAGRAM...
Page 43
All manuals and user guides at all-guides.com BLOCK DIAGRAM (SMPS)
All manuals and user guides at all-guides.com IC BLOCK DIAGRAM IC101 IC104 UM6861/WT62P1 74LS14 DAC2 VSYNC1/INTV DAC1 HSYNC1 DAC0 DAC3 RESET_ DAC4 DAC5 DAC6 OSC0 DAC7 OSC1 P07/HSYNC0 P06/VSYNC0 [CE]P14 P05/DAC13 P13/HALFH1 P04/DAC12 P12/HALFH0 P03/DAC11 P11/AD1 P02/DAC10 P10/AD0 P01/DAC9 P16/INTE P00/DAC8 P31/SCL P30/SDA...
Page 45
All manuals and user guides at all-guides.com...
Page 46
All manuals and user guides at all-guides.com IC102 24C04 HV GENERATOR MEMORY EEPROM ARRAY CONTROL CONTROL (128X8) LOGIC LOGIC XDEC PAGE LATCHES YDEC SENSE AMP R.W CONTROL IC601 TDA9302H FLYBACK GENERATOR POWER AMPLITIER THERMAL PROTECTION IC802 LM2468 Vin 1 Vin 2 Vin 3 Vout 3 Vout 2...
Page 47
All manuals and user guides at all-guides.com IC901 3842 SET/ Vref Vref RESET U.V.L.O. INTERNAL LOGLC BIAS 1/2 Vref C.S. COMP COMP. LATCH OSCILLATOR Ct/Rt IC801 LM1269 To Other Video Channels H Blank H Flyback R OSD Clamp DC Clamp Restore Amp G OSD Analog/...