Before operating the monitor please read this manual thoroughly. This manual should be retained for future reference. Contents Packing list ---------------------------------------------------- Precautions ---------------------------------------------------- Installation Instructions ------------------------------------- Swivel Base -------------------------------------------------- Power cord -------------------------------------------------- Video cable -------------------------------------------------- Operating Instructions -------------------------------------- General Instructions -------------------------------------- Front panel control ---------------------------------------- How to adjust a setting ----------------------------------- Adjusting the picture -------------------------------------...
PRECAUTIONS Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. Do not place the monitor on an unstable cart, stand, or table. If the monitor falls, it can injure a person and cause serious damage to the appliance.
INSTALLATION INSTRUCTIONS Swivel Base To attach the swivel base to the monitor, do the following: • Carefully turn the monitor on its side or upside down. ( see figure 1 ) • Locate the cavities at the bottom front of the monitor. •...
Video cable Connecting the Video Cable: The monitor comes with a built-in video cable. Plug the signal cable's 15-pin connector into the computer's video port and tighten the two screws on the cable connector. Caution:Don’t bend the signal cable, otherwise it will break the inner wire. Connecting the Power Cord: Plug the power cord into the monitor's AC power socket.
OPERATING INSTRUCTIONS General Instructions The power switch is located at front panel of the monitor. Press the power switch to turn the monitor on or off. The other control knobs are located at the base of the monitor (See Figure 3). By changing these settings, the picture can be adjusted to your personal preferences.
Front Panel Control • Power Switch: Press this knob to switch ON/OFF of monitor’s power. • MENU Active OSD menu or function adjust confirm. • Contrast Adiust contrast or function adjust. • Brightness Adjust brightness or function adjust. • EXIT: Press the EXIT key to inactive OSD menu. •...
Adjusting the picture The description for functional control icons 1. CONTRAST Adjust the picture contrast. 2. BRIGHTNESS Adjust the picture brightness. 3. H-CENTER Adjust the horizontal position of the picture. 4. H-SIZE Adjust the picture’s horizontal size. 5. V-CENTER Adjust the vertical position of the picture. 6.
14. USER COLOR ( Red / Blue ) If the 9300°K normal white or 6500°K warmer white do not satisfy your desire, properly adjust R . B GAIN controls to obtain your optimum whiteness level. 15. DEGAUSS If color impurity occurs when moving or swiveling the monitor, press MENU Key and degauss to fix the picture condition.
THIS MONITOR WILL APPEAR TO BE NON-FUNCTIONAL IF THERE IS NO VIDEO INPUT SIGNAL. IN ORDER FOR THIS MONITOR TO OPERATE PROPERLY, THERE MUST BE A VIDEO INPUT SIGNAL. This monitor meets the Power Management standards as set by the Video Electronics Standards Association (VESA) and/or the United States Environmental Protection Agency (EPA) and The Swedish Confederation Employees ( NUTEK ).
TECHNICAL SUPPORT (FAQ) Problem & Question Possible Solution Power LED is not on *Check if the Power Switch is in the ON position *Power Cord should be connected No Plug & Play *Check if the PC system is Plug & Play compatible *Check if the Video Card is Plug &...
Need help?
Do you have a question about the AC511 and is the answer not in the manual?
Questions and answers