Table of Contents
Advertisement
Operating Instructions
Refer to warnings on page 5 before operating the Whirlpool.
1. Ensure power cord is plugged into medical-grade GFCI outlet.
2. Fill tub with water so that the bottom of turbine is at least 15.2 cm (6 inches) below
surface of water.
3. F-270/300/425-S only (Figure 5): To change the lateral position of the turbine:
WARNING: Do not place your hands on the tub railing as they could be injured by the
motion of the carriage assembly.
a. With both hands on the carriage assembly, turn handle clockwise (11) to unlock
carriage assembly from tub and slowly push the carriage assembly to the desired
location.
b. Lock the lateral position of the carriage assembly by turning handle
counterclockwise (11).
4. To change the vertical position of the turbine:
a. F-260-S (Figure 6):
i. Loosen handle (8) to unlock turbine.
ii. Slowly push down on the top of the motor support casting (2) until the bottom of
the turbine is at the desired location.
iii. Tighten handle (8) to lock in place.
b. F-270/300/425-S (Figure 7):
WARNING: Keep your hands on the motor support casting (2) during this operation.
Movement of the lifting mechanism in the carriage assembly (see Figure 5) could
cause injury.
i. Loosen handle (8) to unlock turbine.
ii. Slowly push down on the top of the motor support casting (2) until the bottom of
the turbine is at the desired location.
iii. Tighten handle (8) to lock in place.
Refer to Figure 5 and Figure 6 for the remaining steps:
5. Turn the pressure control valve handle (5) fully clockwise. This will generate maximum
water circulation.
6. Turn the turbine power switch (6) on.
7. Adjust pressure control valve handle (5) to change level of water circulation.
8. Turn the turbine power switch (6) off to stop water circulation.
9. To electrically isolate the Whirlpool from supply mains, simply unplug the Whirlpool at
the wall outlet, if required.
Draining Instructions
Refer to Figure 6 and Figure 7.
1. Turn the turbine power switch (6) off.
2. Turn drain handle (1) to empty tub.
18
WHITEHALL MANUFACTURING P.O. BOX 3527 City of Industry, CA 91744-0527 U.S.A.
Phone (800) 782-7706 (626) 968-6681 Fax (626) 855-4862 https://www.whitehallmfg.com
Advertisement
Table of Contents
