Installing Turbine(S); Installing Thermometer; Installing Headrest - Whitehall F-260-S User Manual

Installing Turbine(s)

NOTE: It is recommended that 2 people mount the turbine
assembly(ies) onto the tub.
For F-260-S (Figure 6),
1. Loosen handle (8) then lower turbine support rod (4) into
tube (3). Tighten handle (8) when turbine is at desired
height.
2. Turn the pressure control valve handle (5) fully clockwise,
then fully counterclockwise to completely lubricate the
plunger assembly.
3. Turn the turbine power switch (6) off.
4. Plug in the turbine assembly into the medical grade GFCI
outlet.
For F-270/300/425-S (Figure 7),
1. Loosen set screw (3) and slide motor support casting (2) onto
tube (4) then tighten set screw (3).
2. Plug turbine power cords into carriage assembly outlets.
3. Turn the pressure control valve handle (5) fully clockwise, then
fully counterclockwise to completely lubricate the plunger
assembly.
4. Turn the turbine power switch (6) off for each turbine.
5. Plug carriage assembly power cords into medical-grade GFCI
outlet.

Installing Thermometer

(Figure 9) Insert sensing rod (3) through upper
bracket (1) and into lower bracket (4), then
tighten screw (2).

Installing Headrest

(Figure 8) Loosen handle (4), insert headrest
rod (2) into raising and lower assembly (3) and
tighten handle (4).
WHITEHALL MANUFACTURING  P.O. BOX 3527  City of Industry, CA 91744-0527 U.S.A.
Phone (800) 782-7706  (626) 968-6681  Fax (626) 855-4862  https://www.whitehallmfg.com
Figure 6: Installing turbine on F-260-S
Figure 7: Installing turbine on F-270/300/425-S
Figure 9: Installing thermometer Figure 8: Installing headrest
17