Using The Powercom Box - UNISENSE SULFILOGGER User Manual

1. Verification of the sensor and battery status of the SulfiLog-
ger™ sensor.
2. Easy access to the data stored in the SulfiLogger™ sensor
device. The data can be exported in csv-file format.
3. Viewing of live data values from the SulfiLogger™ sensor.
To download data from the SulfiLogger™ sensor, simply connect
the RS232 cable to a USB port on a laptop with the SulfiLogger
App installed. Open the SulfiLogger App and press the "Down-
load data" button. The data is stored as a csv-file in the folder
"Unisense Data" in your local documents folder.
U P
SING THE OWER
The combined power and communication box (PowerCom Box) is
a battery box used in connection with the SulfiLogger™ sensor. It
enables the use of the SulfiLogger™ sensor in areas without a 4-20
mA connection. The PowerCom S1 cable is used to connect the
SulfiLogger™ sensor to the PowerCom Box. The sensor cable is
connected to the sensor connector (left side connector on figure
3) on the PowerCom Box.
Data stored on the SulfiLogger™ sensor is downloaded using a
USB cable. Connect a USB cable to the USB port (right side con-
nector on figure 3) and open the SulfiLogger App on your com-
puter. For further information on how to download the sensor
data, see the SulfiLogger App section in this manual.
The battery has a lifetime of about 2 months. When recharging
the battery, use the power cable included with the PowerCom Box.
The battery is recharged after about 6 hours. The SulfiLogger™
sensor cannot be connected to the PowerCom Box while charging.
C B
OM OX
14