Dell Latitude 7480 Owner's Manual page 30

b. battery
c. WLAN card
d. WWAN card
NOTE: To identify the number of screws, see
3. To remove the display assembly:
a. Un route the WLAN and WWAN cables from the routing channels [1].
b. Disconnect the IR camera cable from the system board [2].
c. Remove the M2.0x3.0 screws that secure the eDP bracket [3].
d. Lift the eDP bracket from the eDP cable [4].
e. Lift the eDP cable to disconnect it from the connector on the system board [5].
f. Un route the eDP cable from the routing channel [6].
4. To remove the display assembly:
a. Open the display of the computer and lay it on a flat surface at an 180-degree angle.
b. Remove the M2.5 x 4.0 screws that secure the display hinge to the display assembly [1].
c. Lift the display assembly from the computer.
30 Disassembly and reassembly
screw list