Brookstone Wrist Speaker Quick Manual

Wrist Speaker
BLUETOOTH ® AUDIO
HANDSFREE CALLING
LI-ION BATTERY WARNING
This device contains a Lithium-Ion battery. The battery
must be recycled or disposed of properly. Contact
your local waste management office for information
on battery recycling or disposal.
Use only the supplied cable to recharge the battery.
Improper charging may damage the battery and the
device.
Do not attempt to open the rechargeable battery or
battery pack. There are no serviceable parts inside.
Keep the battery out of reach of children. If
swallowed, consult a physician immediately.
Do not dispose of battery in a fire as it may explode.
The battery may also explode if damaged.
FCC INFORMATION
Caution: Changes or modifications not expressly
approved by the party responsible for compliance
could void the user's authority to operate the
equipment.
This equipment has been tested and found to
comply with the limits for a Class B Digital Device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
CAUTION
equipment generates, uses, and can radiate radio
• Do not drop, crush, bend or apply excessive force
frequency energy and, if not installed and used in
to the device.
accordance with the instructions, may cause harmful
• Do not expose the device to moisture, extreme or interference to radio communications. However, there
prolonged heat, cold, humidity, or other adverse
is no guarantee that interference will not occur in a
conditions. Avoid storage in damp, humid or wet particular installation.
locations. Do not submerge in water.
If this equipment does cause harmful interference to
• Do not attempt to open the Wrist Speaker. There
radio or television reception, which can be determined
are no serviceable parts inside. The unit can only
by turning the equipment off and on, the user is
be opened by qualified personnel.
encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and
• Connect the equipment to an outlet on a circuit dif-
• Consult the dealer or an experienced radio/TV tech-
This equipment complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1. This equipment may not cause harmful interference.
2. This equipment must accept any interference
BC
WARNING: To comply with FCC's RF radiation
exposure limits for general population/uncontrolled
exposure, the antenna(s) used for this transmitter
must be installed to provide a separation distance
of at least 20 cm from all persons and must not be
collocated or operating in conjunction with any other
antenna or transmitter.
FCC ID: AFVN-AR117A2BLA
LOCATION OF PARTS AND CONTROLS
receiver.
CHARGING THE BATTERY
The Wrist Speaker includes a rechargeable Lithium-
ferent from that
Ion battery, which must be charged before first use.
to which the receiver is connected.
To charge the battery:
1. Plug the charging cable's USB connector into a
nician for help.
2. Plug the charging cable's Micro USB connector
received, including interference
that may cause undesired operation. PAIRING WITH BLUETOOTH
You use Bluetooth
to the speaker, and to answer telephone calls through
the speaker. Using a MicroSD card or the FM Radio
feature does not require Bluetooth
Note: If you are using a MicroSD card, remove the
card before beginning the pairing procedure. If a
MicroSD card is present, the speaker will not enter
pairing mode.
1. Prepare your device (e.g., smartphone) to pair
using Bluetooth
Mode Button
within 33 feet of the Wrist Speaker. Refer to your
Under Protective Cover:
Volume +
MicroSD Slot device's owner's manual for information on using
Volume -
the Bluetooth
Micro-USB Port
Power/Play/Pause
2. Press and hold the POWER/PLAY/PAUSE
LED Indicator
Button until the LED Indicator flashes blue quickly
and the voice prompt indicates that the speaker is
in pairing mode.
3. On your device, search the list of available devices
and select Wrist Speaker. Note that it may take
a few seconds for the speaker to be listed as an
available device. Depending on your device, you
may have to tap SCAN to update the device list.
Consult your device's owner's manual.
4. If prompted, type the password or PIN 0000.
When paired, the speaker's LED Indicator will flash
blue slowly and the voice prompt will advise you that
the device is paired.
USB port on an active device or a USB Adapter.
The devices will remain paired, even after being
turned off, until you cancel pairing. Consult your
device's owner's manual for information on cancelling
into the Micro USB port on the Wrist Speaker. The
pairing.
LED Indicator turns red during charging. It flashes
blue and red when the speaker is fully charged. A If no music is streaming for more than 30 seconds,
full charge takes approximately 2 hours. the speaker enters standby mode. The LED Indicator
flashes blue slowly. The devices remain paired in
® standby mode for up to 48 hours.
® to stream audio from your device
USING A MICRO SD CARD
To play MP3/WAV music from a MicroSD card on
.
® your Wrist Speaker, insert a MicroSD card into the
MicroSD slot. Press and hold the Volume + and
Volume — buttons to control volume; short press
Volume +/— to select the next/last song.
The Bluetooth
owned by Bluetooth SIG, Inc. and any use of such marks by
Brookstone is under license.
® , making sure that the device is
function.
®
® word mark and logos are registered trademarks