rameder 8.30.07.9001 Manual page 15

To fit the support bars, open the cover of the support feet. To do this, insert the key and turn it to the left
into the vertical position (Figure 3a). Then fold the cover upwards (figure 3b).
Carefully place the support bars on the roof rails and align them as shown in figure 2.
Caution
The claws of the support bar feet must completely enclose the railing on the underside.
The outer claw in each case must not be attached to the railing groove.
1. First hand-tighten the clamping screws in all support legs. Then tighten the clamping screws in all
outriggers one after the other to 6 Nm using the torque spanner. The two
2. arrows on the torque spanner must be exactly opposite each other (6 Nm) so that the two supporting
rods are secured in the longitudinal and transverse directions (figure 3d).
3. Close all covers and lock the lock. To do this, turn the key to the right into the horizontal position and
remove it.
4. Finally, insert the cover profiles if necessary.
To mount body parts, open the support leg cover as described
Note:
Do not put any load on the folded-down cover! Remove the cover profile and insert the body parts into the
existing T-slot. Close the support leg cover again.
14