NOMA Miles Instruction Manual page 6

4
Toll Free: 1-866-827-4985 model no. 052-6966-2
ASSEMBLY
Installation
1. Mounting bracket
Note: The mounting bracket depicted will vary
depending on the model (see Fig. 4).
. Secure the mounting bracket to outlet box marked
"ACCEPTABLE FOR FAN SUPPORT" and use
outlet box screws provided with outlet box (see Fig. 4).
2. Attach blade to motor
. Remove three screws from flange cover and
lift the cover set aside. Remove three screws
from top plate located on the motor yoke. Lift
top plate and set aside.
. Time Saver: Washers can be set on each blade
screw prior to installing blades.
. Locate 15 blade attachment screws and washers in
hardware pack. Slide blade through centre band and
align holes. Insert 3 blade attachment screws and
washers with fingers. Tighten securely with a
screwdriver. Repeat for the remaining blades.
. Reattach top plate to motor yoke and install it by
aliging the keyslot holes on the motor yoke using
previously removed screws (see Fig. 5).
Note: The reverse switch must be sited in the
rectangle hole labelled on the top plate.
3. Drop-mount and hands-free wiring
. Slide downrod through canopy and flange cover.
. Thread electrical wires through downrod and pull
extra wire slack from the upper end of the downrod.
. Loosen yoke set screw and nut and remove pin and
clip if preinstalled. Place downrod into the motor
housing yoke and insert pin and clip. Tighten yoke
set screw and nut securely (see Fig. 6).
.
Carefully lift the fan assembly onto the mounting
bracket.
.
Rotate the fan until the notch (b) on the nylon
ball fits against the ridge (a) on the mounting
bracket (see Fig. 7a).
. With the mounting bracket holding the fan assembl y,
follow wiring instructions (step 4).
4
Wood screw
with flat washer
Set screw
5
Motor yoke
Electrical wiring
6
7a
a
Top plate
Blade
Centre band
Downrod
Pin
Yoke set screw
b