Hide thumbs Also See for Lakefront Systems:

Advertisement

S H O R E S T A T I O N
L A K E F R O N T S Y S T E M S

ShoreStation Hydraulic Wireless Pairing Instructions

Pair the wireless controllers with the lift controller.
o Unlock the key fobs.
o Turn the lockout key to the ON position.
o Trip the top limit switch 10 times in less than 30 seconds. The light 1 output should
flash once to indicate it is in pairing mode. This process is the same for when no upper
limit switch is installed and the jumper wire is installed. Pull the plug apart, slide one
side in until a connection is made then tap other connection 10 times.
o Press the UP or DOWN button on the wireless control once. The Light 1 output
should flash once to indicate it paired with the wireless control. Repeat for the other
controller.
o The Light 1 output should flash 2 times after a few seconds to indicate it is no longer
in pairing mode.
o Test the wireless controllers to see if they run the lift. If not, the wireless controls may
need to be replaced.
Doc Midwest Industries, Inc. Ida Grove, IA 51445
800-859-3028
www.shorestation.com
0004441
Page 1 of 2
Rev 3.4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Lakefront Systems and is the answer not in the manual?

Questions and answers

Summary of Contents for ShoreStation Lakefront Systems

  • Page 1 S H O R E S T A T I O N L A K E F R O N T S Y S T E M S ShoreStation Hydraulic Wireless Pairing Instructions Pair the wireless controllers with the lift controller.
  • Page 2 S H O R E S T A T I O N L A K E F R O N T S Y S T E M S ShoreStation Power Winch Wireless Pairing Instructions Safety Instructions Step 1 – Unlock the remote control •...

Table of Contents