Advertisement
The length of Bulb (32) is set to 11 minutes and 30 seconds, User Programmable Interval 99 is set to
11 minutes and 33 seconds. These last two settings are used to tell your camera to stop recording at
11:30 just before the 12 minutes 4 GB FAT 32 file size limit is reached. The the Pclix will then wait 3
seconds while the camera finishes saving the file at which time another start trigger will be sent to the
camera and recording will continue. The length of these last two settings can be changed if you wish.
Quick Canon Setup Programming Sequence (45):
- Turn the Pclix XT OFF
- Set the programming code to 45
- While pushing the red Fire button turn ON Pclix XT to enter programming mode
- After 3 RED LED flashes release FIRE button
- Both the RED and GREEN LED will flash 1 time
- Push FIRE button once to confirm the loading of the Quick Canon Setup
- The GREEN LED will flash 4 times to indicate the Quick Canon Setup has been loaded
- Turn OFF the Pclix XT to exit programming mode
- Reset both dials to zero
Save User Setup (46)
The Pclix XT has the ability to save one complete setup into flash memory. When you perform a save
all User Preferences including camera model, image count settings, bulb settings, custom intervals,
start delay settings, etc, etc., will be saved into flash memory for later recall.
Save User Setup Programming Sequence (46):
- Turn the Pclix XT OFF
- Set the programming code to 46
- While pushing the red Fire button turn ON Pclix XT to enter programming mode
- After 3 RED LED flashes release FIRE button
- Both the RED and GREEN LED will flash 2 times.
- Push FIRE button once to confirm you want to Save the current Setup.
- The GREEN LED will flash 4 times to indicate you have successfully Saved your Setup
- Turn OFF the Pclix XT to exit programming mode
- Reset both dials to zero
Recall User Setup (47)
The Pclix XT has the ability to recall one complete setup from flash memory. By performing this
function you will replace the current Pclix XT settings with the ones saved in memory. All user settings
including camera model, image count settings, bulb settings, custom intervals, start delay settings,
etc, etc., will be recalled and available the next time the Pclix XT is turned ON.
Recall User Setup Programming Sequence (47):
- Turn the Pclix XT OFF
- Set the programming code to 47
- While pushing the red Fire button turn ON Pclix XT to enter programming mode
- After 3 RED LED flashes release FIRE button
- Both the RED and GREEN LED will flash 3 times
- Push FIRE button once to confirm you want to Recall the Saved Setup
- The GREEN LED will flash 4 times to indicate your Saved Setup has been Recalled
- Turn OFF the Pclix XT to exit programming mode
- Reset both dials to zero
Pclix XT User Manual 3.2
22 of 28
1017 Visual Effects Inc. - copyright © 2011
Advertisement
