IKEA UNDVIKA Manual page 8

B, Parent Unit
NOTE! Make sure the parent unit is at least a couple of metres
away from the baby unit before you switch it on. If the units are
too close to each other, feedback between the units can create a
loud screeching noise.
1. S witch the power on by turning the On/Off switch (10) from
0 to 1. When the power is on, the battery indicator (12) lights
up green. If the indicator starts blinking red, the unit needs
to be charged.
2. Y ou can adjust volume of the speaker (17) from 1 (lowest) to 3
(highest) using the Volume control (10).
3. W hen a signal is received, the Sound level indicator (13) will
light up in three levels depending on the intensity of the
sound transmitted from the baby unit. At level 3 the unit will
also vibrate.
This indicator is useful for monitoring your child when the
volume of the parent unit is set on low.
4. W hen the parent unit is in contact with the baby unit, this
is indicated by a green steady light on the Range indicator
(15). If the units are out of contact with each other the range
indicator will start blinking red. There will also be a beeping
signal to alert your attention. This signal is also activated if
the baby unit is switched off.
5. Y ou can talk to your baby through the parent unit to the
baby unit by holding the Talk back button (16).
8