Table of Contents
Advertisement
5.
Using the Q35
In this section you will find useful information about installing the Q35 as well as connecting the device to
a power supply and a network.
5.1.
Installation
The Q35 should be mounted clear of any metal obstructions (e.g. air-conditioning ducts, large ceiling
trusses, building superstructures) to the side or front of the device. In case needed, use a rigid conduit to
lower the Q35 away from these obstructions.
Installation Using VESA Mount
Selecting Compatible Mounting Bracket
The Q35's mounting holes are arranged according to VESA MIS-F, 200, Y, 6 standard (Four M6 threaded
holes in 200x200mm pattern). Select your mounting bracket according to the requirements set
by the installation environment. Please note that some mounting bracket models may prevent access to
cable connectors when installed. Make sure that the mounting bracket can carry the weight of Quuppa
Q35 (1,3 kg) and possible wind loads .
WARNING
Never attach, mount, or connect the mounting bracket to hot surfaces. Always make
sure that the surface can carry the weight of the equipment before installation.
WARNING
Not following general safety regulations can cause damage to objects or injuries to
people. Rely on qualified personnel for carrying out the installation of Quuppa
devices.
7/21
Quuppa Q35 Locator Installation Guide and Safety Information
Quuppa Oy, Keilaranta 1, 02150 Espoo, Finland
© 2020 Quuppa Oy
Customer Confidential
Advertisement
Table of Contents
