Table of Contents
Advertisement
CHAPTER 5: ADDRESSING
5.1.2 SETTING UP KEYPAD BUTTONS ADDRESS
1. Push the keypad button addressing switch on the rear side of keypad using a small screwdriver or wire; backlight LEDs are
switched off to indicate Set Address Mode.
2. Button LEDs indicate ADDRESS in binary code—Button 1 bit 0, Button 2 bit 1 etc. Push buttons to toggle address bits to the
requested value of ADDRESS.
3. Push the keypad button addressing switch to save an ADDRESS to non-volatile memory and to enter keyboard Standard Mode.
Backlight LEDs switch on to indicate Standard Mode.
FIGURE 5-2. KEYPAD BUTTON ADDRESSING SWITCH
FIGURE 5-3. BUTTON ADDRESSES
1.877.877.2269
IR receiver addressing switch
Keypad button addressing switch
BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
9
Advertisement
Table of Contents
