Before Operating - Sharp SMD2499FS Operation Manual

Before operating your new Convection Microwave Drawer, make
sure you read and understand this operation manual completely.
• Before the Convection Microwave Drawer can be used,
follow these steps:
1 Plug in the Convection Microwave Drawer.
will appear.
MICROWAVE TOUCH CLEAR
2 Touch the STOP/CLEAR pad. : will appear.
3 Set clock.
TO SET THE CLOCK
1 Touch TIMER/SETTINGS pad once.
SET CLOCK ENTER TIME.
2 Touch number pads for correct time of day, press START/
+30 SEC.
This is a 12 hour clock. If you attempt to enter an incorrect
clock time, will appear in the display. Touch the STOP/
ERROR
CLEAR pad and re-enter the time.
• If the electrical power supply to your Convection Microwave
Drawer should be interrupted, the display will intermittently
show
ENJOY YOUR MICROWAVE TOUCH CLEAR
is reinstated. If this occurs during cooking, the program
will be erased. The time of day will also be erased. Simply
touch STOP/CLEAR pad and reset the clock for the correct
time of day.
Note:
• The Convection Microwave Drawer can be programmed
with the drawer open except for START/+30 SEC.
STOP/CLEAR
Touch the STOP/CLEAR pad to:
1 Erase if you make a mistake during programming.
2 Cancel timer.
3 Stop the Convection Microwave Drawer temporarily during
timed cooking.
4 Return the time of day to the display.
5 Cancel a program during cooking, touch twice for timed
cooking.
ENJOY YOUR
The display shows
TO
after the power
13

BEFORE OPERATING

OPEN OR CLOSE CONVECTION
MICROWAVE DRAWER
Press the OPEN/CLOSE pad on the glass touch control or wave
twice on top left side of the drawer to open the microwave. The
Easy Wave Open only works to open the microwave, not close.
The Convection Microwave Drawer also can be closed by gently
pushing on the drawer. Do not pull the drawer by hand, except
in the case of emergency, such as a power failure. If necessary,
push or pull slowly.
EASY WAVE OPEN ON/OFF
Easy Wave Open's default setting is OFF when plugged in. The
white light on the center of the panel will illuminate once Easy
Wave Open has been activated. When Control Lock is activated,
the Easy Wave Open function is off.
To use the Easy Wave Open function, simply wave your hand
in front of the sensor twice in consecutive motions. This can be
either up and down or side to side motions.
EASY WAVE OPEN ON
• Hold Number 5 on the glass touch control for 3 seconds
display shows
EASY WAVE OPEN ON.
EASY WAVE OPEN OFF
• Hold Number 5 on the glass touch control for 3 seconds
display shows
EASY WAVE OPEN OFF
. The
. The
.