Table of Contents
Advertisement
EN
N.B.: : The emergency stop signal function is active in modes 1, 2, 3.
N.B.: On the website www.n-com.it / Support section, you can find a video tutorial that shows how to adjust the
sensitivity of the brake light.
6.
REAR LIGHT (mode 2)
The tail light makes it possible to activate the bottom LEDs of the ESS system, keeping them on during the entire ride.
If the emergency brake light is activated during braking, all LEDs will start flashing.
7.
POOR VISIBILITY LIGHT (mode 3)
The poor visibility light allows you to be more visible in case of fog or limited visibility. If selected, the bottom LEDs of
the ESS system will flash intermittently.
If the emergency brake light is activated during braking, all LEDs will start flashing.
18
Advertisement
Table of Contents
Need help?
Do you have a question about the N-Com R Series and is the answer not in the manual?