Running A Presentation - Proxima Media Express Supplementary Manual

1. The Show Slides setting lets you run the entire presentation, or a
sequential part of it. To run a part of the presentation, indicate the
numbers of the first and last slides in the sequence.
2. The Advance setting lets you choose whether to manually advance from
slide to slide. If you choose Enable automatic advance, each slide will
advance according to the timing you indicate for it in the Advance section
of the Transition Selector dialog box.
3. The Loop Continuously setting lets you play the presentation over and
over until you stop it manually. Press the MediaExpress key on the
Cyclops remote control or Stop on the toolbar to stop the presentation.
4. The Show Presentation toolbar setting lets you use the toolbar during
the presentation. The Toolbar has buttons that make it easier to advance
or reverse through slides with the Cyclops wand or laser pointer. It also
offers a Preview window that you can use to skip or preview slides.
Note: The settings you choose in this dialog box will remain in effect until
you turn off the projector (except for the From xx to xx setting). After the
projector has been turned off, the MediaExpress settings revert to the factory
defaults. The settings are: show all slides, manual advance, continuous loop
off, and the Show Presentation toolbar on.

RUNNING A PRESENTATION

To begin the presentation, adjust the following settings as needed and click
OK (if you want to use the Preview feature, make sure you check the Show
presentation toolbar checkbox).
The next illustration shows how to run a presentation using the Cyclops
remote control. You can also run your presentation from the Toolbar using
the Cyclops wand or optional laser pointer. See the section "The Toolbar"
for details.
2-6 Chapter Two