Related Manuals for International Light Technologies ILT770
Summary of Contents for International Light Technologies ILT770
- Page 1 ILT770 UV Light Meter Operation Manual 10 Technology Drive Peabody, MA 01960 Ph: 978-818-6180 Fax: 978-818-6180 Web: www.intl-lighttech.com ILT770 UV METER Page number 1 or 9...
-
Page 2: Table Of Contents
Table of Contents 1. Introduction 2. Button Features 3. Taking a Measurement 3A. Taking a measurement first time users 4. Graphing 5. Battery 6. Sensor 7. USB Ports 8. Calibration 9. Warranty 10. Software ILT770 UV METER Page number 2 or 9... -
Page 3: Introduction
ILT770 UV Light Meter Instruction Manual 1. INTRODUCTION The ILT770 is a hand held UV meter designed to measure both irradiance in Watts per square centimeter (W/cm²) and dose/exposure in Joules per square centimeter (J/cm²). The system comes comfingured with one UV sensors and is calibrated as a set (paired meter/sensor). -
Page 4: Taking A Measurement
Min reading Max readings Average The ILT770 has the ability to apply meta data to the saved results. See Applying meta data in chapter 10 software, on page 8. 4 GRAPH MODE The Graph button has four functions (Start Graph, Stop/Review Graph, Data Analysis and Exit) that cycle forward each time button 4 is pressed. -
Page 5: Graphing
60 readings when used for longer duration's. If the sensor is moved slowly under a lamp, The ILT770 can map the uniformity of the output over the target area. If the sensor is held stationary, graph mode can verify the stability of the lamps output. -
Page 6: Battery
The battery on the ILT770 includes a 1200 mA hour rechargeable lithium battery that will run the ILT770 for up to six hours of continuous use. The Battery is rated to last for 300-500 charge cycles. To conserve battery life, the ILT770 will automatically shut off after 5 minutes unless plugged into a power source or conducting a graph measurement. -
Page 7: Sensor
6. SENSOR The ILT770 has been paired with the sensor and calibrated to create a NIST traceable calibrated light measurement system. Swapping sensors between meters can cause inaccurate results. Please verify your meter and sensor serial number on your calibration certificate if there is a chance your have swapped sensors. -
Page 8: Warranty
ILT770 device Data Download: The ILT770 can save up to 1000 readings in its internal memory. Using the PC software users can download the saved data to a PC for analysis, reporting and system verification. - Page 9 ILT770 UV METER Page number 9 or 9...
Need help?
Do you have a question about the ILT770 and is the answer not in the manual?
Questions and answers