Advertisement
To receive the signal of the belt, you must install it on the chest by moistening well the sensors. If
it was not recognized after several attempts of repositioning, try to pair it again by using this mode.
Each heart rate belt has a unique identification number, that can not be changed. When the belt is
driven (moistened and then installed on the chest) it automatically transmits its identification
number to Keymaze.
The "pairing" allows the Keymaze to detect stimulated belts that are near of 10 meters and
store their ID number. You must be isolated during this phase in order to to appair an other one.
By default the Keymaze 700 comes paired with heart rate monitor belt in the package. It is therefore
not necessary to use the "pairing" before the first use.
However, the "pairing" can be used when you want to use another belt.
This mode allows you to update your Keymaze from the interface Geonaute Software.
This mode allows you to update your Keymaze from the interface Geonaute Software and get the
latest enhancements.
This requires to be connected to your PC with the USB cable and that the Geonaute Software is
working.
Reference
g/ Heart Rate Belt Pairing
(KEYMAZE 700 only)
h/ Update the Keymaze
Version Number
Advertisement
