Related Manuals for CORNING 1LAN-SPLT-132-486C
Summary of Contents for CORNING 1LAN-SPLT-132-486C
- Page 1 ONE SD-LAN Wall Mount Splitter Housing (1LAN-SPLT-132-486C) CMA-477-AEN 1 General | Figure 1 STANDARD RECOMMENDED PROCEDURE 000-000-AEN | ISSUE 1 | MARCH 2018 I Page 1...
-
Page 2: Carton Contents
ONE SD-LAN Wall Mount Splitter Housing (1LAN-SPLT-132-486C) 2 Carton Contents | • Installation instruction • Wall Mount Splitter housing • Cable installation hardware 3 Tools and Materials Required | 3.1 Tools • Can wrench • Measuring tape • Appropriate tool kit with fiber stripping tools 3.2 Materials... - Page 3 ONE SD-LAN Wall Mount Splitter Housing (1LAN-SPLT-132-486C) 4.1 Wall Mounting PSU6 (Remote Power Option) Step 1 Remove the rack-mounting brackets and set the screws aside. Using the four screws (previously set aside), Step 2 assemble the wall-mount brackets onto the sides of the PSU6 so that the unit can be mounted belly-to-wall.
- Page 4 ONE SD-LAN Wall Mount Splitter Housing (1LAN-SPLT-132-486C) 5 Accessing the Housing | Step 1 Use a 3/8-in can wrench to loosen the security screw on the front cover. Depress the access latches on the side of the Step 2 unit and open the front cover (Figure 5).
- Page 5 ONE SD-LAN Wall Mount Splitter Housing (1LAN-SPLT-132-486C) 6 Installing Feeder Cable| Step 1 Remove the hole plug for the feeder entry port. Install an appropriate size fitting and conduit (if conduit is used) per standard local practices and ensure proper sealing. Feed the end-point cables into the housing through the fitting.
- Page 6 ONE SD-LAN Wall Mount Splitter Housing (1LAN-SPLT-132-486C) 7 Installing End-Point Cable | Spare end-point fiber connectors can be stored in a parking area on the front of the connector plate. Individual connectors can be accessed as new subscribers are activated.
- Page 7 ONE SD-LAN Wall Mount Splitter Housing (1LAN-SPLT-132-486C) Step 1 Remove one of the hole plugs from the bottom of the housing. Install an appropriate size fitting and conduit (if conduit is used) per standard local practices and ensure proper sealing. Feed the end- point cables into the bottom chamber through the fitting.
- Page 8 ONE SD-LAN Wall Mount Splitter Housing (1LAN-SPLT-132-486C) Figure 9 8 Connecting End-point Connectors during Initial Installation | Step 1 Select the appropriate connector from the parking area (Figure 10) Figure 10 STANDARD RECOMMENDED PROCEDURE 000-000-AEN | ISSUE 1 | MARCH 2018 I...
-
Page 9: Connector Care And Cleaning
ONE SD-LAN Wall Mount Splitter Housing (1LAN-SPLT-132-486C) Remove the dust cap from the appropriate connector adapter. Clean each adapter before mating as Step 2 described in Section 9. Align the key on the connector with the key on the connector adapter. Install the connector into the Step 3 adapter. -
Page 10: Maintenance And Repair Procedures
The graphical display of loss over a cable’s entire length provides the most revealing analysis and documentation available on a cable link, commonly referred to as its signature trace. Corning recommends performing an OTDR analysis to document the integrity of the cable system, locate and measure each event or component, and uncover faults throughout the cable.
Need help?
Do you have a question about the 1LAN-SPLT-132-486C and is the answer not in the manual?
Questions and answers