Table of Contents
Advertisement
4 Familiarising yourself with your appliance
4.1 Control panel
You can use the control panel to configure all functions
of your appliance and to obtain information about the
operating status.
4.2 Indicators/symbols
The displays show selected values and functions.
Display
Name
-
Heat settings
/
Residual heat
Electronic boil start control
4.3 Touch fields
Touch fields are touch-sensitive surfaces. To select a
function, touch the relevant field.
Touch
Name
field
Main switch
Electronic boil start control
Hotplate selection
Childproof lock
Wipe protection
Settings range
or
Automatic zone control
Notes
¡ Always keep the control panel dry. Moisture impairs
the function.
¡ Do not pull pans close to the displays and touch
fields. The electronics may overheat.
4.4 Hotplates
You can find an overview of the different activations of
the hotplates here.
If you operate the activations, the relevant displays light
up.
5 Basic operation
5.1 Switching the hob on or off
The main switch is used to switch the hob on and off.
If you switch the appliance back on again within
4 seconds after switching off, the hob will start up with
the previously stored settings.
5.2 Switching on the hob
Touch
.
▶
a The indicator lamp above
a The
displays light up.
a The hob is ready for use.
lights up.
Familiarising yourself with your appliance en
If you switch on a hotplate, it will switch to the setting
last selected.
Hot-
Name
plate
Single-circuit
hotplate
Dual-circuit
hotplate
Dual-circuit
hotplate
Notes
¡ Dark areas in the glow pattern of the hotplate are
part of the technical design. They do not affect the
functionality of the hotplate.
¡ The hotplate regulates the temperature by switching
the heat on and off. The heat may also switch on
and off when on the highest setting.
Reasons:
– Easily damaged components are protected
against overheating.
– The appliance is protected from electrical over-
load.
– This achieves a better cooking result.
With multi-circuit hotplates, the heating of the hot-
plate and the activated areas may switch on or off
at different times.
4.5 Residual heat indicator
The hob has a two-stage residual heat indicator for
each hotplate. Do not touch the hotplate while the re-
sidual heat indicator is lit up.
Display
Meaning
The hotplate is so hot that you can
keep small dishes warm or melt cook-
ing chocolate.
The hotplate is hot.
5.3 Switching off the hob
The hob will switch off automatically when all hotplates
have been switched off for a while (10-60 seconds).
Touch
.
▶
a The indicator lamp above
a The displays go out.
a All hotplates are switched off.
a The residual heat indicator remains on until the hot-
plates have cooled down sufficiently.
5.4 Setting the hotplates
To set a hotplate, it has to be selected.
Select the required heat setting on the control panel.
Activating and deactivating
Select hotplate.
Select hotplate and touch
or
.
Select hotplate and touch
goes out.
.
5
Advertisement
Table of Contents
