Table of Contents
Advertisement
Fault
and the heat setting flash al-
ternately. A signal sounds.
and audible signal
and hotplates do not heat up
A message with "E" appears on
the display, e.g. E0111.
15 Disposal
Find out here how to dispose of old appliances cor-
rectly.
15.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
Dispose of the appliance in an environmentally
▶
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
16 Customer Service
If you have any queries on use, are unable to rectify
faults on the appliance yourself or if your appliance
needs to be repaired, contact Customer Service.
Detailed information on the warranty period and terms
of warranty in your country is available from our after-
sales service, your retailer or on our website.
Cause and troubleshooting
Several hotplates have been used over a prolonged period at high power set-
tings. The hotplate has been switched off to protect the electronics.
Wait a while.
1.
Touch any control.
2.
a When the message no longer appears, the electronics have cooled down
sufficiently. You can continue cooking.
Despite being switched off by
hotplates have therefore been switched off.
Wait a while.
1.
2.
Touch any control.
a When the message no longer appears, the electronics have cooled down
sufficiently. You can continue cooking.
Hot pan near the control elements. There is a risk of the electronics overheating.
Remove the pan.
▶
a The display goes out shortly afterwards.
Hot pan near the control elements. The hotplate has been switched off to pro-
tect the electronics.
Remove the pan.
1.
Touch any control.
2.
a When the message no longer appears, the electronics have cooled down
sufficiently. You can continue cooking.
The hotplate was on for too long and has switched off automatically.
You can switch the hotplate back on again immediately.
Demo mode is activated.
Disconnect the appliance from the power supply for 30 seconds by briefly
1.
switching off the circuit breaker in the fuse box.
Touch any control within the next 3 minutes.
2.
The electronics have detected a fault.
Switch the appliance off and on again.
1.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales service. Please specify the
2.
exact error message when calling.
→ "Customer Service", Page 11
, the electronics have become hot again. All
This appliance is labelled in accord-
ance with European Directive
2012/19/EU concerning used elec-
trical and electronic appliances
(waste electrical and electronic equip-
ment - WEEE).
The guideline determines the frame-
work for the return and recycling of
used appliances as applicable
throughout the EU.
If you contact Customer Service, you will require the
product number (E-Nr.) and the production number
(FD) of your appliance.
The contact details for Customer Service can be found
in the enclosed Customer Service directory or on our
website.
Disposal en
11
Advertisement
Table of Contents
