Table of Contents
Advertisement
___________________________________________________________
Positions
Each switch has a "Positions" setting which controls its behavior, and settings which control the
lighting of the LED's behind the top and the bottom of each switch.
There are two possible settings for this parameter that control the behavior of the switch:
2 Position: The rocker switch acts as a two-position toggle switch. When powered on, the indicator
for the top of the switch will transmit the state OFF, and the indicator for the bottom of the switch will
transmit the state ON, and these two values will remain the same until the top of the switch is
pressed. When the top of the switch is pressed, the indicator for the top of the switch will transmit
the state ON, and the indicator for the bottom of the switch will transmit the state OFF, and these
two values will remain the same until the bottom of the switch is pressed. When the bottom of the
switch is pressed, the indicator for the top of the switch will transmit the state OFF, and the indicator
for the bottom of the switch will transmit the state ON, and these two values will remain the same
until the top of the switch is pressed.
3 Positions: The rocker switch acts as two momentary switches. When powered on, the indicator for
the top of the switch will transmit the state OFF, and the indicator for the bottom of the switch will
also transmit the state OFF. When the top of the switch is pressed, the indicator for the top of the
switch will transmit the state ON as long as the top of the switch is pressed. When the top of the
switch is released, the indicator for the top of the switch will again transmit the state OFF. When the
bottom of the switch is pressed, the indicator for the bottom of the switch will transmit the state ON
as long as the bottom of the switch is pressed. When the bottom of the switch is released, the
indicator for the bottom of the switch will again transmit the state OFF.
Top and Bottom Data Instance and Indicator
If the Use As Backlight option is deselected, this Data Instance and Indicator will be the instance
information in which the VMM6 will be tethered to via PGN.
The LED behind the corresponding switch will be lit or flashing whenever the Indicator that
corresponds to the selected Data Instance is transmitting an On or fault state on the network. The
LED on the switch will be dark otherwise.
(If the "Use As Backlight" option is selected the value of these fields will be ignored.)
VMM6 User's Manual Rev.1.1
Table 4 – Indicator Reference Number
Top
Switch
Indicator
Number
Number
1
1
2
3
3
5
4
7
5
9
6
11
Bottom
Indicator
Number
2
4
6
8
10
12
10
Advertisement
Table of Contents
