Connecting The Scsi Interface Cable - Seagate Scorpion 40 Installation Manual

12

Connecting the SCSI interface cable

Scorpion 40 drives can be used with three different types of
SCSI interfaces: Ultra2 SCSI (LVD), "Wide" (16-bit) single-
ended SCSI, and "Narrow" (8-bit) single-ended SCSI. The
drive can automatically detect whether it is connected to an
LVD or single-ended wide SCSI bus.
Note: The Scorpion 40 will not work in a SCSI-1
Connecting to a 68-pin Wide SCSI or LVD bus
To connect the drive to an LVD or SCSI wide bus, first turn
off all power to the drive and computer. Then attach the
interface cable to the SCSI interface connector on the back of
the drive (see Figure 5 below).
Figure 5
Interface connectors on internal Scorpion 40
Ultra2 SCSI 68-pin high-density connector
environment.
pin 34
pin 68
Scorpion 40 Installation Manual, Rev. A
pin 1
pin 35