Software Activation - ALK CoPilot Truck Laptop 4 User Manual

6. At the end of the installation you'll be prompted to activate the software. CoPilot must
be activated within 15 days after installation in order for you to continue using it.
Follow the instructions in the Software Activation section below.
7. Plug the GPS receiver into your laptop. See Hardware Setup, p. 20-22.
NOTE: The receiver must be attached before you can use CoPilot for guidance.
8. Make sure the date and time are set correctly on your computer. This is extremely
important for CoPilot to function properly. To check and/or change the date and time, go
to the Windows Start button, Settings, Control Panel, Date/Time.
To start CoPilot, double-click on the CoPilot Truck | Laptop 4 icon that was created on
your laptop when you installed the program. To quit at any time, select Exit from the File
menu in Planning Mode, or Exit in the Guidance Mode navigation control panel.
NOTE for XP Users: If you are installing CoPilot on a computer running Windows XP,
you may be prompted to connect your GPS receiver during installation. If you are using the
USB GPS receiver, Windows XP will pop up a message warning you about Windows Logo
testing. Click Continue Anyway if this warning appears.

Software Activation

At the end of CoPilot's installation process, you will be prompted to activate the software.
CoPilot must be activated before you can use it. NOTE: You can install and activate
CoPilot on your desktop computer (for trip planning) and your laptop (for in-vehicle
guidance) using the same Installation Product Key.
Follow the steps below to activate your software:
1. At the end of the software installation,
the License Activation Wizard will
appear. If you cancel this screen, it
will appear again the first time you
open CoPilot. For automatic
activation, follow the on-screen
instructions and click Next.
- 16 -