Chapter 1 - Installation Guide
Connect the remaining end, the 3-Row male connecter side, to your PC's VGA
out 3-Row female connector port. This port can be found by following your moni-
tors cable to the back of your PC. Remove the monitor cable from the port and
replace it with the Superscan cable mentioned above. The VGA port looks like the
picture below.
The cable below is the short cable (2-Row Male to 3-Row Female VGA Pass-
through Cable) that came in your Superscan package. Again, look closely at the
type of connectors and amount of pins. Remember, this is a short male to female
cable.
Connect the 2-Row Male connector to the port on the Superscan labelled "Thru
Out" as shown in the picture below.
Connect the remaining end, the 3-Row female connecter side, to the monitor
cable you disconnected from the VGA out port in the directions above. Notice
how it connects in the picture on the following page.
12