Setting Up; Anchor To Concrete Floor; Assembly; Cabinet To Cabinet - GARANT GridLine 930505 Instruction Manual

GARANT GridLine tool cabinets
NOTICE
Improper transport
Damage to items of packaging.
» Handle items of packaging in accordance with the symbols and instructions shown on them.
» Do not drag them across the floor.
» When items of packaging are being transported they must be upright, secured with ropes and
protected against slipping.
» Be aware of the centre of gravity.
en
» Use the lifting points provided.
» When putting them down, do so slowly and evenly.
» Do not remove the transport packaging until immediately before erection.
» Once the device has been erected at the place of erection, remove the transport restraints.

5. Setting up

i
Applies to: Tool cabinet, corner cabinet, auxiliary cabinet, CNC auxiliary and tool cabinet
 Set up on a solid, level floor suitable for the maximum load capacity of the cabinet.
 Use a spirit level to check horizontal levelling of the cabinet. If necessary, use shim wedges.

5.1. ANCHOR TO CONCRETE FLOOR

A
ü Wall plugs and screws chosen to match the nature of the floor.
ü Floor has sufficient load-bearing capacity.
ü Bottom drawers or pull-out shelves removed.
1. Mark drilling spots through the holes in the cabinet's rear and move cabinet out of the way.
2. Make hole Ø 8 mm with a depth of 60 mm.
3. Insert the plugs and position the cabinet according to where the holes are.
4. Bolt cabinet to floor.

6. Assembly

CAUTION
Assembly work
Risk of crushing feet or hands when assembling and when closing drawers.
» Wear safety shoes and safety gloves.
» Ensure safe footing on clean, level surface.
» Do not assemble by yourself.

6.1. CABINET TO CABINET

B
ü Cabinets are of identical height and depth. Otherwise drill through cabinet wall.
1. Insert four M6×12 bolts through both side walls at top and bottom.
2. Screw on four M6 nuts from the other side.
26 Instruction manual