Midi With All The Input/Output Midi Implemented Controls Available - Polyend Tracker Instructions Of Use

step numbers start with 00 and use sixteen digits (A means 10, B means 11, and
so on all the way to F which means 15). This allows for easy alignment with music:
bars will always start with pattern steps 00, 10, 20, 30 and so on. Each bar's
quarternote beat steps end with the digits ..0, ..4, ..8, and ..C.
Pads preview – Off, Track, Pattern > On the Pattern editor screen, the grid pads
can highlight the notes in the active line. Choose between highlighting only the
active track's notes, or the entire pattern's active line,

MIDI with all the input/output MIDI implemented controls available:

Clock In – Internal, USB, MIDI In jack,
Clock Out – Off, USB, MIDI Out jack, USB + MIDI Out, jack,
Transport In – Off, USB, MIDI In jack, USB + MIDI In jack,
Transport Out – Off, USB, MIDI Out jack, USB + MIDI Out jack,
Notes in mode – Off, USB, MIDI In jack, USB + MIDI Out jack,
Notes In channel – All, Ch1 to Ch16,
MIDI Out mode – Off, USB, MIDI Out jack, USB + MIDI Out jack,
MIDI Out mode – Off, USB, MIDI Out jack, USB + MIDI Out jack,
MIDI Out mode – Off, USB, MIDI Out jack, USB + MIDI Out jack,
CC/PC Out channel – outputs from Ch1 to Ch16,
CC Out – CC from A to E with available communicate numbers from 1 to 127,
Metronome: State (on/off), Pre Roll (on/off), Time signature num & denum (from 1 to
12), Volume (from 0 to 100).
Firmware: check the current version, update firmware version and perform the Config
reset if needed.
File transfer: enables Media Transfer Protocol mode which allows browsing files and
folders stored on your SD card from a computer level.
Manual: view the onboard Polyend Tracker Quick-Start.
Credits.