Operation - EGO ST1510E Operator's Manual

NOTICE:
The front-assist handle should be turned
EN
upwards to point toward the top of the rear handle.
WARNING:
Only fix the front-assist handle between
the soft sleeve and the label on the shaft.
WARNING:
The tool can not be used without the
front-assist handle securely fixed.
MOUNTING THE SHOULDER STRAP
1. Loosen and remove the bolt in the hook of the strap
(Fig. J1 & J2).
2. Attach the hook onto the shaft as Fig. J3 shown and
lock it with the bolt (Fig. J4).
WARNING:
Only fix the hook of the strap between
the housing and the soft sleeve on the shaft.

OPERATION

WARNING:
Do not allow familiarity with this
product to make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety
glasses with side shield, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or
accessories not recommended by the manufacturer of
this product. The use of attachments or accessories not
recommended can result in serious personal injury.
WARNING: To prevent serious personal injury,
remove the battery pack from the tool before servicing,
cleaning, changing attachments or removing material
from the unit.
You may use this product for the purposes listed below:
Trimming: used for removing grass and weeds up against
walls, fences, trees and borders.
Cutting: used for cutting the grass that is difficult to
reach using a normal mower.
NOTICE:
The tool is to be used only for its prescribed
purpose. Any other use, for example edge trimming, is
deemed to be a case of misuse.
ATTACHING/DETACHING THE BATTERY PACK
NOTICE: For better balance, when you use BA3360/
BA4200/BA4200T/BA5600T batteries, please
cooperate it with the backpack harness(BH1000).
12
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1510E
Fully charge before first use.
To Attach
Align the battery ribs with the mounting slots and press the
battery pack down until you hear a "click" (Fig. K2).
To Detach
Depress the battery-release button and pull the battery
pack out as Fig. L shown.
Fig. K1 & K2 parts description see below:
BA3360/BA4200
/BA4200T/
K-1 K-4 Latch
BA5600T battery
pack
K-2 Adaptor K-5 Battery-mounting Slot
Backpack
K-3
harness
HOLDING THE LINE TRIMMER
WARNING:
Dress properly to reduce the risk of
injury when operating this tool. Do not wear loose
clothing or jewelry. Wear eye and ear/hearing protection.
Wear heavy duty, long trousers, boots and gloves. Do not
wear short trousers, sandals or go barefoot.
Before operating, hold the trimmer with both hands, one
hand on the rear handle and the other on the front-assist
handle which shall be straight (Fig. M). Then check for
balanced footing and a proper cutting distance.
NOTICE:
The trimmer head is parallel to the ground at a
proper cutting distance without the operator bending over.
STARTING/STOPPING THE LINE TRIMMER
To Start
Press down the lock-off button then depress the trigger.
Different pressure on the trigger results in variable
rotating speed of the cutting line. More pressure, higher
speed.
To Stop
Release the lock-off button and the trigger.
NOTICE:
The motor runs only when the lock-off button
and trigger are both pressed.
WARNING:
Always remove the battery pack from
the line trimmer during work breaks and after finishing
work.