Safety Information - vacuubrand DVR 2 Instructions For Use Manual

Safety information!

Remove all packing material, remove the product from its packing-box, remove the
protective covers and keep them, inspect the equipment.
If the equipment is damaged, notify the supplier and the carrier in writing within three
days; state the item number of the product together with the order number and the
supplier's invoice number. Retain all packing material for inspection.
Do not use the equipment if it is damaged.
If the equipment is not used immediately, replace the protective covers. Store the
equipment in suitable conditions.
☞ Read this manual before installing or operating the equipment.
☞ Obey all applicable regulations and realize all required measures.
☞ Position the vacuum gauge and the vacuum connection in the vacuum system in a
way that no draining of condensate towards the pressure transducer inside the
vacuum gauge can occur.
The current supply of the devices is realized by the incorporated 9V battery.
☞ Recommended type see section "Technical data".
☞ The battery is free from mercury and cadmium.
☞ The battery must not be charged, opened, thrown into fire, heated to more than
100°C or brought in contact with water.
☞ When replacing the battery, always insert it correctly into the battery compartment.
☞ When using a battery with a different chemical system (e. g. alkaline), lifetime may
be considerably shorter.
☞ The use of an accumulator is not recommended because of its low capacity.
The devices are not suitable when working with dangerous or explosive gases or
explosive or flammable mixtures. Ensure that the materials of the wetted parts are
compatible (see "Technical data"). If necessary adopt suitable measures.
Max. permitted pressure at the vacuum gauge: 2 bar absolute.
☞ The display flashes at pressures above 1060 mbar.
Max. ambient temperature for storage and operation: 60°C.
Max. temperature of gaseous media at the pressure transducer (gas!): 80°C.
Ensure that maintenance is done only by suitably trained and supervised technicians.
Ensure that the maintenance technician is familiar with the safety procedures which
relate to the equipment processed by the vacuum system and that the equipment if
necessary is approximately decontaminated before starting maintenance.
Use only genuine spare parts and accessories.
☞ Otherwise safety and performance of the equipment as well as the electromagnetic
compatibility of the equipment might be reduced.
In order to comply with law (occupational, health and safety regulations and regulations
for environmental protection) products returned to the manufacturer can be repaired /
DKD calibrated only when following certain procedures (see section "Notes on return
to the factory").
11.12.2002