Table of Contents
Advertisement
A
4.
Turn Allan cap screw A counter clockwise to
loosen clamp body B. The two threaded nuts C
are there to help spread the clamp body.
Note: Spread clamping mechanism only as needed. Nuts
C
have no other purpose and you will notice that they are
locked together and will sit in a neutral position when the
router motor is secured into place.
E
E
Note: Some motors have pins or protrusions
housing. You will need to turn/twist the motor as you slide
it into the clamping area, or onto the reducer collar.
H
2. Adjust the height of the router in the collar H to
ensure that the router is as close as possible to the
underside of the plate without touching I.
20
B
C
E
E
on the
Close but not touching
I
D
D
Note: When mounting the Milwaukee model 5625/5626
motor, please ensure that a shim
and the clamping surface of the lift.
5.
Slide the router motor into the clamping area as
shown above using shim or reducers if necessary.
F
G
For installation with reducer collar
1. Install the collar onto the router as shown in F, and
then fit the router with collar into the lift, G, making
sure that the collar flange sits flush against the
clamping bracket.
J
3. With the router in position, tighten clamping bolt J
securely, using a using a 8 mm Allen key, but do not
over tighten. Important: Test that the router is se-
curely clamped in the reducer collar by trying to
twist the router in the collar by hand.
D
is between the router
tighten
Advertisement
Table of Contents
