Table of Contents
Advertisement
P
Q
7. Attach the two bottom side cross braces, P and Q.
8. Turn the stand in the upright position and attach
the middle cross brace on the left side, as shown
in R.
W
11. Insert a phillips head screw with hex nut through
both holes on the middle cross brace, and from
the other side of the brace, lightly thread a hex
nut to lock the screws in position
X
9. Install the switch box by sliding it's mounting brack-
et over the right front leg X, and attach with the two
phillips head screws and washers already mount-
ed to the bracket.
12
U
R
9. Using a carriage bolt, flat washer and nut, S,
The router lift crank handle may be stored on the holder as
shown in V when not being used.
The insert ring wrench may be stored on one of the
screws as shown above.
.
W
10. Stand assembly is now complete.
S
T
attach the router lift crank handle holder T to the
middle cross brace as shown in U.
V
Advertisement
Table of Contents
