Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
SERIOUS PERSONAL INJURY COULD OCCUR IF YOU CONNECT THE MACHINE TO THE POWER SOURCE BEFORE YOU HAVE COMPLE-
TED THE INSTALLATION AND ASSEMBLY STEPS. DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL INSTRUCTED TO DO
SO.
40-060 ROUTER TABLE STAND
Note: Do not tighten the stand bolts until after you have fastened the stand to the router table top. (See step 3 on
page 14.)
A
1. Attach a rubber foot to each leg using a phillips
screw, flat washer and hex nut A, in the assembly
order shown in B.
F
G
3. Using 4 carriage bolts with flat washers and hex nuts,
F, attach one leg to one top brace and one top
cross brace as show in G, in the assembly order
shown in H.
M
L
K
J
5. Attach a third leg K to the top brace J, then attach
second top cross brace L, then fourth leg M.
B
D
C
E
2. Lay the stand braces and legs on the floor as
shown. This will help you to rapidly locate the
braces and know what to attach where.
Note: Bottom brace C goes on the rear of the stand and
bottom brace D goes on the front. Put middle cross brace,
E, aside for now.
H
4. Using the same hardware, attach a second leg to
the top cross brace, I, then attach the second top
brace J to this leg, as shown.
6. Attach the rear bottom cross brace N and the front
bottom cross brace O as shown.
REAR
FRONT
I
J
N
O
11
Advertisement
Table of Contents
