Description Of Parts / Supplied Parts; Intended Use; Unpacking The Appliance; Preparation - Profi Cook PC-FW 1060 Instruction Manual

CAUTION:
Do not immerse the device into water for cleaning. Please follow the
instructions as stipulated in the chapter "Cleaning".
• Do not break up hard items such as bones or shells.
• Do not manipulate safety switches.

Description of Parts / Supplied parts

1 Filling tray
2 Motor
3 Switch / /R (On/Off/reverses)
4 Screw
5 Spiral housing
6 Pusher
Illustrations A to D:
7 Spiral
8 Knife
9 3 Steel discs (fine, medium, coarse)
10 Plug
11 Sausage attachment
12 2-part "Kebbe" attachment
13 2-part cookie attachment
14 Rail for biscuits

Intended use

This appliance serves
• Cut up foodstuff.
• You can shape noodles or dough with different
attachments.
It is exclusively intended for this purpose and may
be only used appropriately.
It may only be used in the manner described in
these operating instructions.
You may not use the appliance for commercial
purposes.
Use for any other purpose is considered improper
and not for the intended purpose and can result in
damage to property and personal injury.
44
The manufacturer shall not be liable for damages
caused by not intended use.

Unpacking the appliance

1. Remove the device from its packaging.
2. Remove all packaging materials like foils, filling
materials, cable holders, and carton packaging.
3. Check the scope of deliveries for completeness.
4. If the packaging content should be incomplete
or if damages should be noticeable, do not
operate the appliance. Return it to the distributor
immediately.

NOTE:
There may still be dust or production remains on
the device. We recommend that you clean the
device as described under "Cleaning".

Preparation

Please see the overviews on pages 3 and 4.
1. Open the holder for the screw housing with the
screw (4).
2. Fit the screw housing (5) into the screw drive
with the filing neck vertical. Retighten the screw
clockwise
3. Place the filling tray on to the filler neck in such
a way that the fixture for the tray is above the
motor block.
4. Push the spiral (7) into the horizontal section of
the spiral housing until the axle locks in place.
See also the sections on assembling the meat
grinder, the "Kebbe" attachment, the sausage
attachment or the biscuit attachment.