Normal Appearance Of Signals; Attaching The Myosync To A System; Calibration - Noraxon MyoSync 262 User Manual

MyoMOTION Data Logger User Manual
Section 7: Pre Section 7: Pre Section 7: Pre Section 7: Pre- - - - Use

Normal Appearance of Signals

The MyoSync's Sync Source indicator provides a means of communicating its operational state.
In the PC state the PC light will illuminate to indicate the sync pulse is generated by the PC. In
the EXT state the EXT light will illuminate to indicate the sync pulse is generated by an external
source plugged into the external Sync In port.
If the Not Ready indicator is red, the MyoSync is not setup properly.
Note: When first plugged in, the Not Ready light will illuminate until the setup process is
complete.

Attaching the MyoSync to a System

Normally systems are connected to the MyoSync using one of the attachment ports (Wireless,
EXT Sync In, or Sync Out) as described previously in section 6. If the indicators are illuminating
properly but the software is giving an error when running a measurement, check to make sure the
connectors are secure in their ports and no individual wires or cables are disconnected.

Calibration

Calibration of the MyoSync itself is not required.
P-2628 Rev B
Use C C C C heck Use Use heck- - - - Out heck heck Out Out Out
9