HP 3PAR StoreServ 7450 Service Manual page 53

8. Verify the OS version is correct. Type c and press Enter to continue.
Patches: None
Component Name
CLI system
CLI Client
System Manager
Kernel
TPD Kernel Code
Enter < C > to continue or < Q > to quit
9. Verify the number of drives in the storage system. Type c and press Enter to continue.
10. If there are any missing or nonstandard connections, an error message displays. Verify that
all nonstandard connections are correct or complete any missing connections, then type r
and press Enter to recheck the connections. If it is necessary to quit the setup procedure to
resolve an issue, type q and press Enter When all connections are correct, type c and press
Enter to continue.
1 1. The system prompts you to begin the system stress test script. Type y and press Enter. The
system stress test continues to run in the background as you complete the system setup.
At this point, it is recommended that the OOTB stress test be started.
run heavy I/O on the PDs for 1 hour following 1 hour of chunklet initialization.
The results of the stress test can be checked in approximately 2 hours and 15
minutes. Chunklet initialization will continue even after the stress test
completes. Select the "Run ootb-stress-analyzer" option from the console menu
to check the results.Do you want to start the test (y/n)? ==> y
12. When finished, type c and press Enter.
13. Create spare chunklets as directed.
CAUTION: HP recommends that at least four physical disks worth of chunklets be designated
as spares to support the servicemag command. The default sparing options create an
appropriate number of spare chunklets for the number of disks installed.
Select one of the following spare chunklet selection algorithms:
Custom allows specifying the exact number of chunklets, but is not recommended
as spares must be manually added when new disks are added.
Enter "Ma" for maximal, "D" for default, "Mi" for minimal, or "C" for custom: D
Selecting spare chunklets...
14. Verify the correct license is displayed and press Enter. If the license information is not correct,
type c and press Enter to continue with the system setup. After completing the system setup,
contact your local service provider for technical support to obtain the proper license keys.
15. Complete the network configuration:
a. When prompted, type the number of IP addresses used by the system (usually 1) and
press Enter.
b. Type the IP address and press Enter.
c. Type the netmask and press Enter. When prompted, press Enter again to accept the
previously entered netmask.
d. Type the gateway IP address and press Enter.
Version
3.1.2.xxx
3.1.2.xxx
3.1.2.xxx
3.1.2.xxx
3.1.2.xxx
==> c
Manually Initializing the Storage System Software
This will
53