Manually Initializing The Storage System Software; Manually Setting Up The Storage System; Service Processor Connector Pin-Outs - HP 3PAR StoreServ 7450 Service Manual

Service Processor Connector Pin-outs

Use at the SP end of a standard Ethernet cable and in conjunction with the laptop adapter (PN
180-0055-01) to allow serial connection to the SP.
DB9 (Female) RJ45
Pin 2-Pin 3 (orange)
Pin 3-Pin 2 (black)
Pin 5-Pin 5 (green)
Figure 47 Service Processor Connector Pin-outs

Manually Initializing the Storage System Software

Use the following procedures to manually set up the storage system and SP when access to the
wizards is not available.
NOTE: You must physically connect a laptop to the SP to complete these procedures. See the
section "Connecting a Laptop to the SP" in the HP 3PAR StoreServ 7450 Storage Installation Guide.

Manually Setting up the Storage System

The Out-of-the-Box (OOTB) script guides you through setting up and configuring the storage system
software:
1. Connect the PC to the controller node 0 through a serial cable and log in with user ID
console.
2. From the Console Menu, select option 1, Out of The Box Procedure.
3PAR Console Menu 1400293-1 3.1.2.xxx
1. Out Of The Box Procedure
2. Run ootb-stress-analyzer
3. Re-enter network configuration
4. Update the CBIOS
5. Enable or disable CLI error injections
6. Perform an IDE rescue
7. Set up the system to wipe and rerun ootb
8. Cancel a wipe
9. Perform a deinstallation
10. Update the system for recently added hardware (admithw)
11. Check system health (checkhealth)
12. Exit
> 1
WARNING!
of data. Do not perform this procedure on a system that has already undergone the system
setup. If you quit this setup script at any point, you must repeat the entire process
Proceeding with the system setup script causes complete and irrecoverable loss
Manually Initializing the Storage System Software 51