Midi Control - DIGISYNTHETIC DS212 Instruction Manual

(band). Select GAIN (gain) Menu to increase or decrease desire dB gain in selected frequency. "+" Means
increase in level and "-" means decrease. During SINGLE & AUTO mode, you are not able to edit any
Filter parameter. You are only able to adjust Filter parameter in these modes for similar filter frequency
and octave band with 0dB gain. Simply press FILTER MODE button and hold for 2 seconds to re start a
lock Filter by selecting SINGLE or AUTO mode.
3.4.4 Store Sequence
Use STORE button to activate store sequence. Basically, all edited parameter in parametric EQ mode is
able to store & save. Filter will adjust automatically and save required data under SINGLE & AUTO mode
operation. E.g.:
To edit a sequence by function button & jog wheel. LCD displays 2 seconds interval blinking "SV" (save)
symbol, this is to indicate preset has been edited but not been save yet. Press FILTER SEL button to enter
sequence select channel manual, press STORE button once and "SV" symbol will blink fast in 1-second
interval. In order to maintain original setting, you may use jog wheel to select an editable different preset
channel no. Press STORE button again, "SV" symbol will disappear and save data in the selected preset
store channel no. If user wish to change original preset, simply press STORE button twice after editing
to store all the changes.
Remarks: When you change a preset and press STORE button twice, then all the data before this preset
will be void and only new parameter will be rewrite. But if you wish to keep previous setting, then you
have to select another preset store channel no (by jog wheel) before you press STORE button second time.

3.5 MIDI control

Use the MIDI key combination to select the MIDI parameters you wish to adjust. For this purpose press and
keep the IN/OUT and the STORE buttons. All parameters can be edited with the jog wheel and the IN /OUT
button. The MIDI menu includes 6 pages, which you can select by pressing the IN/OUT button several times.
In page 1, you are able to select MIDI channel as display "CH-XX" in screen. User is able to select channel
from OFF to 1 through 16 by jog wheel. To disable MIDI function, simply select "OFF".
You are able to select full MIDI mode in 2 page. This means the unit transmits/receives on all 16 MIDI
channels. "Omni" will display in screen and by turning jog wheel to "ON" or "OFF" to enable or disable
all function modes.
User is able to configure controller commands in the 3 page. "CONTROLX" will display in screen and jog
wheel selects one of the following 4 controller modes:
Display
CONTROL0
CONTROL1
CONTROL2
CONTROL3
CONTROL4
When you select controller 4, you may select different menus from frequency, gain, fine tune frequency.
DS212 will send auto filter parameter.
The fourth page gives you access to the program change setup. The display reads "ProgramX", here, too.
Four modes can be selected with the jog wheel, as follows:
Page 8
n d
rd
Modes
No controller data are transmitted
Controller data are received but not transmitted
Controller data are transmitted but not received
Controller data are transmitted and received
Similar to 3 with Filter sequence no
Fig.3.2 Controller Settings