3Com OfficeConnect 3CRWDR100B-72 User Manual page 19

Figure 5 Connecting the Router
Power
Supply Unit
Telephone
Socket
Splitter/
Microfilter Block
1 Run the provided telephone cable from the wall jack providing ADSL
service to the ADSL port on your ADSL Router. When inserting an ADSL
RJ-11 plug, be sure the tab on the plug clicks into position to ensure that
it is properly seated. If you are using splitterless ADSL service, add
low-pass filters between the ADSL wall jack and your telephones. (These
filters pass voice signals through but filter data signals out.)
2 Then:
If you are using a full-rate (G.dmt) connection, your service provider
■
will attach the outside ADSL line to a data/voice splitter. In this case
you can connect your phones and computer directly to the splitter as
shown below
or
If you are using a splitterless (G.lite) connection, then your service
■
provider will attach the outside ADSL line directly to your phone
system. In this case you can connect your phones and computer
directly to the incoming ADSL line, but you will have to add low-pass
filters to your phones as shown below
3Com OfficeConnect
ADSL Wireless 11g Firewall Router
Your PC
(Figure 6):
Connecting the Router
Wireless
Users
(Figure 7)
19