Table of Contents
Advertisement
Adjust Front and Rear Grass
Shields
Note: When operating in turf conditions where much
debris is encountered, or unusually heavy thatch, open
the front and rear discharge shields to help allow the
debris to discharge from the reel.
1. Loosen the capscrews on the pivot of the grass shield.
2. Rotate the grass shield to the desired setting and tighten
the capscrew.
3
1
Figure 4
1. Front grass shield
2. Rear grass shield
3. Front grass shield
mounting screws
Caution
Do not open rear shield so it is higher than level to
ground
Thrown debris could cause personal injury
Adjusting the Roller Scrapers
1. Loosen flange nut securing roller scrapers (Fig. 5).
2. Move scraper rods in or out to attain 0.0 to 0.03 in.
(.0 to .75mm) clearance between the scraper and roller.
2
4
3
4. Rear grass shield
mounting screw
Figure 5
1. Front roller scraper
2. Rear roller scraper
3. Ensure that the scraper rod is parallel to the roller and
the level surface.
4. Tighten flange nuts to lock adjustment.
Mount Verticutting Reel
Important
When lowering verticutting reels, care
must be taken to prevent damage to the reel blades due
to contact with a concrete floor or a paved surface.
Verticutting reels, can be installed at any of the three
mounting locations on the traction unit. Figure 6 shows the
orientation of the hydraulic drive motor for each of the
locations. For the #3 location requiring the motor to be
mounted on the left end of the cutting unit, switch the
counter weight from the left end of the cutting unit to the
right end of the cutting unit.
Figure 6
Note: Counter weights are shipped installed to left end of
the verticutting reels. The capscrews on the right end are
used for securing the hydraulic motor.
5. Verticutting reels are mounted to traction unit the same
way cutting units are. Refer to Traction Unit Operator's
Manual for mounting instructions.
6
2
1
Advertisement
Table of Contents
