Saving Measured Values; Displaying A Saved Value - Westfalia Wetekom JT-60 Instruction Manual

Calculations and Memory Management
The result and the units of measurement (y.y
To subtract areas ad volumes, use

Saving Measured Values:

The distance meter is equipped with SEVEN memory registers, of which 5 act
as memory (M1 to M5) and 2 as calculation memory (buffer memory
).
The 5 Memory Registers (M1 to M5)
To see which memory registers are occupied, activate the unit with a random
measuring and then press
appear in the display. If no data at all is stored, no memory register is
displayed.
When you press
pressing lets the other registers (M2 to M5) flash one after another.
To wipe all memory registers at once, press
registers flash. Now press
To store a measured value, do as follows:
If you have measured a distance, area, or volume, the value is shown in the
display. Press
which you want to store the value, flashes.
After that, press
(M1 to M5) will disappear in the display.

Displaying a Saved Value:

To have a stored value displayed, press
reached the desired memory register (M1 to M5).
When you have reached the desired memory register, press
the value stored there displayed.
. Only the memory registers, which contain data
again, the first memory register (M1) flashes and further
and all stored memory is erased.
repeatedly, until the memory register (M1 to M5), in
and the displayed value is saved. The memory register
3 3
, ft.ft , or m
instead of
repeatedly, until all 5 memory
repeatedly, until you have
35
3
) are displayed.
.
to have
and