Functions Of The Buttons - Westfalia Wetekom JT-60 Instruction Manual

Functions of the Buttons

Single-Mode
18 meters (without the target unit).
Dual-Mode
with the target. You can measure distances of 1 - 75 m.
Measured distance is from the front end of the unit. In the lower
right corner of the display appears this symbol.
Measured distance is from the rear end of the unit. In the lower
right corner of the display appears this symbol.
1. If you press this button for a short time, the measured value is deleted
from the display.
2a. The unit is set to meters from the factory. If you prefer other units of
measurement, first take a value with the
activate the unit.
2b. After that, select the desired system of units by pressing
than 2 seconds. The unit flips through the different units (m / ft:in / ft.ft
/ y.y). On the desired system just release the button and the
measured values are displayed in the selected system. (also see
page 25).
3. Press the button again to switch the unit into standby.
Addition of simple distances, areas, and volumes.
Subtraction of simple distances, areas, and volumes.
Multiplication of values to reach areas or volumes.
Switching between memory registers.
When the memory symbol flashes, the current value in the display can
be stored in the memory with this button.
When the memory symbol flashes, the value in the memory can be
displayed with this button.
Functions of the Buttons
Use this mode if you want to measure distances of up to
Use this mode if you want to measure longer distances
24
or the buttons to
for more